Vitec Multimedia HDM850+ Uživatelský manuál stáhnout pdf (Strana 25)

CONFIDENTIAL – No part of this document may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic or

mechanical, photocopying, recording, or otherwise, for any purpose, without the prior written permission of VITEC MULTIMEDIA.

VMC-7440_v8_0_6_Quick Start_V1_0_0.doc

Date: 3/18/2013

page 25 / 51

As described previously, the Livewire Setting Page allows user to configure the software

configuration of the product.

6.4.4. Select an assembly.

User can select the assembly to work with.

Assembly defines the operation mode of the product. (See paragraph 7.)

6.4.5. Configure the video and audio input format.

Just below, user can select the “IO” preset. To capture properly a video signal with this

application, user has to select the “IO” preset following the detected format shown in the

Device Internals parameter.

If you click on the “IO” node, you display the device section. . You can here expand

device section to list all parameters show in a list box and then you can select the

relevant video input following detected format.

If necessary, it is possible to fine tune input configuration by modifying Device

parameter value.

6.4.6. Configure the “Capture Ch1” and “Capture Ch2” profiles.

Before encoding, user has to select the “Capture Ch1” and “Capture Ch2” presets below

the current “Base” preset.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 50 51

Žádné komentáře

Vitec Multimedia HDM850+ Uživatelský manuál Strana 25